E-commerce Search Demo
AI Assisted Filters
Parameters
Query:
Category filters: All
AI Assist: ON
Page: 1
Products
Time taken: 5 Max score: 1000.000 Total hits: 600 Full time: 0.0 s
Showing 1-10 of 600 products
![]() B002866BL6 Price: $29.76 Score: 1000.000 Category: Tools Rating: 4.3 Votes: 17 Find similar productsLittle Giant ACS-4 In-Line Condensate Drain Overflow Shut-off Switch, 24 VAC, 72 inch Leads, Black/White, 599125. The Little Giant ACS-4 in-line switch is designed to detect condensate drain line clogs or blockages and shut off equipment or alert users to the potential overflow condition. ACS-4 installs on 3/4 PVC condensate drain pipe in either a horizontal or vertical position. Using the included 3/4 PVC drain pan fitting, ACS-4 can also be installed directly at the drain pan secondary outlet to detect pan overflow and shut off equipment or alert users to the potential overflow condition. | ![]() B01N3CMHCA Price: $18 Score: 7.353 Category: Tools Rating: 4.4 Votes: 31 Find similar productsAll-Access Model AA2-FS A/C Float Switch for Secondary Outlet of Drain Pan. Instructions: Note: Remove float switch before gluing device in place. Note: Failure to follow instructions may cause injury or property damage. Disconnect power to unit prior to installation, servicing or cleaning. Close & latch cover after each use. Test switch operation & clean device at least every three (3) months. Place warning label (included) in visible location. Device must be level or sloped downward from drain pan outlet. When installing the switch bracket back into the device ensure that the wires are seated properly into the groove on the side of the device body. Installation: Thread the included fitting into the auxiliary outlet of pan using thread sealant & glue the device onto fitting. Note: Allow enough space above the device to open cover. To adjust switch sensitivity: To make switch less sensitive remove switch from the “c” clip and re-install to middle groove on switch. Test all fittings for water leaks. Wiring: Disconnect power to unit before wiring. Add fuse & time delay to protect 24-volt circuit & to prevent excess cycling. Connect switch wires in series with either red or yellow t-stat wires. Testing: Plug primary outlet of pan & fill pan with water. With unit running the switch should shut unit before water overflows pan. Adjust sensitivity if needed and re-test. To inspect, clean or add drain line cleaners: Shut power to unit, open cover & clean any debris found inside the device. Add drain line cleaner if desired. Close & latch cover securely. |
![]() B01J6INU8K Price: $64.95 Score: 7.246 Category: Tools Rating: 4.7 Votes: 10 Find similar productsSJE Rhombus PumpMaster 1002732 20FT (Normally Open/Pump Down). Pump switches provide automatic pump control. The SJE PumpMaster pump switch is designed to directly control pumps up to 1/2 HP at 120 VAC and 1 HP at 230 VAC in potable water, water and sewage applications.The SJE PumpMaster pump switch is not sensitive to rotation or turbulence, allowing it to be used in both calm and turbulent applications. 20 foot wire attached U.S. Patent No. 5,087,801 and 5,142,108 Does not include mounting clamp. The product does not have a plug on the end. Hardwire installation. | ![]() B0032FGZ3Q Price: $213.28 Score: 6.803 Category: Tools Rating: 5 Votes: 2 Find similar productsZoeller 10-2042, Switch-Mate Single Piggyback Vertical Float Switch (Normally Open), 115 Volt, 13 Amp Max, 15 ft Cord. Zoeller Switch-Mate Piggyback Variable Level Float Switch Features Standard normally open (NO) 'pumps down' Standard normally open (NO) 'pumps down' Optional normally closed available (NC) 'pumps up', consult factory Optional normally closed available (NC) 'pumps up', consult factory Maximum operating temperature for 10-0748 is 120°F (49°C), all other switches 140°F (60°C) Maximum operating temperature for 10-0748 is 120°F (49°C), all other switches 140°F (60°C) Float is omnidirectional (no 'up' side) Float is omnidirectional (no 'up' side) Includes mounting clamp Includes mounting clamp Designed for effluent, sewage and dewatering applications Designed for effluent, sewage and dewatering applications Variable level float switch, for use in 18 minimum diameter basins Variable level float switch, for use in 18 minimum diameter basins 10-0748, 25' cord standard, no molded plug, can be used as a control switch to operate an external magnetic or combination starter on three phase pumps 10-0748, 25' cord standard, no molded plug, can be used as a control switch to operate an external magnetic or combination starter on three phase pumps Vertical piggyback float switch, ideal for narrow diameter basins - 6-1/2 maximum cycle range Vertical piggyback float switch, ideal for narrow diameter basins - 6-1/2 maximum cycle range Use recommendation chart for switch selection Use recommendation chart for switch selection Does not contain mercury Does not contain mercury NOTE: Remove plug if present and use with Junction Box 10-0002 when field wiring is required. |
![]() B004ZNUZ4E Price: $87.35 Score: 6.757 Category: Tools Rating: 3.9 Votes: 23 Find similar productsLittle Giant RS-5 115-Volt Piggyback Diaphragm Pump-Down Switch, 18-Ft. Cord, Black, 566009. Little Giant's piggyback diaphragm switch converts any manual pump up to 1/2 HP (115V, 15 maximum running Amps) to automatic operation. Includes an 18-foot power cord. Designed to operate in water the compact design works well in limited space. The switch can be used by attaching it to the the discharge pipe of to control on-off operation of the pump. The switch is activated by pressure to a diaphragm, caused by rising water around the switch housing. The switch activates the pump when water reaches 8 inches and shuts the pump off when water falls to 2 inches (+/- 0.5 inches). This switch is ideal for use with pond or fountain pumps. | ![]() B09NVQ3MPF Availability: Currently unavailable Score: 6.667 Category: Tools Rating: 4.1 Votes: 23 Find similar productsHaoguo AC Float Swith for HVAC, Easy Installation, Replacement. Product Description: The AC float switch can be installed on the auxiliary outlet of the primary drain pan, detects clogged A/C condensate drain and shuts off the system, using the 3/4 adapter. Easy access to the switch and main drain for servicing. |
![]() B00CONIYKO Availability: Currently unavailable Score: 6.623 Category: Tools Rating: 4.2 Votes: 77 Find similar productsSquare D by Schneider Electric 9013FHG49J59 Air-Compressor Pressure Switch, 175 psi Set Off, 40 psi Fixed Differential, 1/4 NPT External. This product is part of the NEMA Pressure Switches range, an offer of air compressor switches. This air compressor switch has 2 normally closed, snap action, DPST-DB (double pole single throw, double break) form YY contacts and off at 175psi pressure setting value. The pressure switch with a pressure sensor size of 200psi, an adjustable range on rising pressure of 100psi to 200psi and approximate fixed differential of 40psi. It is furnished with screw clamp terminals for electrical connection and 0.25inch NPT external for fluid connection. This low HP switch has a diaphragm actuator which can be operated from any position and fixed differential scale for internal settings. The enclosure is made of polypropylene. It is available in size of 2.78inch (W) x 3.76inch (D) x 3.92inch (H) and weighs 1lb. It is suitable for pressure controlling or monitoring of water pumps, compressors, agricultural/irrigation water systems, molding presses, injection molders, grinding machines, machining centers, complex and special machines. It is an IP20 and NEMA 1 rated product. This product is certified by CE, CSA and UL. Meets UL 508 standards. Every pressure switch has two operating points, one on rising pressure and one of falling pressure. The operating point on rising pressure is referred to as the TRIP POINT or cut out for pumps and compressors. Power pressure switch rated for the direct control of motors in compressor applications. Rugged, robust construction provides a long life and years of uninterrupted, worry-free service. Electromechanical switch to monitor and control pressure conditions for industrial and end-user applications. Every pressure switch has two operating points, one on rising pressure and one of falling pressure. The operating point on rising pressure is referred to as the TRIP POINT or cut out for pumps and compressors. Power pressure switch rated for the direct control of motors in compressor applications. Rugged, robust construction provides a long life and years of uninterrupted, worry-free service. Electromechanical switch to monitor and control pressure conditions for industrial and end-users applications. | ![]() B0000AXCUU Price: $84.99 Score: 6.623 Category: Tools Rating: 5 Votes: 3 Find similar productsAir Pressure Switch for Single-Stage and Dual-Stage Air Compressor - 1/4in. Male Fitting. Quality-built air compressor pressure switch has a range of 100 to 175 PSI. Built-in unloader for loadless starting. For 115 Volt compressors up to 2 HP and 230 Volt compressors up to 3 HP with a maximum of 15 Amps. 1/4in. male pipe fitting. UL and CSA Listed. UL Listed: Yes, CSA: Yes, Stage: Single or dual, Max. PSI: 175. |
![]() B000KE3SYG Price: $21.45 Score: 6.579 Category: Tools Rating: 4.9 Votes: 22 Find similar productsAmerican Granby PS4060 Pressure Switch. GRANBY PRESSURE SWITCH - Domestic duty, two pole pressure switch for home water systems, connection. 1/4 I.P.T. pressure range cutout 20-80 lbs. Differential 10 lb.-30 lb. size 2 11/16, 3 11/16 x 3 7/8. | ![]() B00HRF31AC Availability: Currently unavailable Score: 6.494 Category: Tools Rating: 4.4 Votes: 191 Find similar productsLeviton 16794 20-Amp 120-Volt Manual Reset Right-Angle GFCI Plug. Leviton's Portable GFCI Devices are now sleeker and more rugged than ever! And, while these devices are fully OSHA compliant for use on job sites, they are also perfect for use in a variety of temporary power applications, such as recreation vehicles, marine vehicles, portable pools, portable generators, submersible pumps, vending machines and more. |









