E-commerce Search Demo
AI Assisted Filters
Parameters
Query:
Category filters: All
AI Assist: ON
Page: 1
Products
Time taken: 4 Max score: 1000.000 Total hits: 100 Full time: 0.0 s
Showing 1-10 of 100 products
![]() B01BURJVOC Availability: Currently unavailable Score: 1000.000 Category: Electronics Rating: 3.9 Votes: 317 Find similar productsMicca OriGen Plus HiFi USB and Optical DAC Amp for Headphones and Powered Speakers, 24-Bit/192kHz, Earphone Amplifier, Preamp, Volume Control, for Desktop Computers and Laptops. The Micca OriGen USB audio DAC and preamplifier is a studio master grade digital audio playback and control center that supports high-resolution PCM audio up to 24-bit/192kHz. Its powerful preamp and headphone amplifier, along with flexible input and output configurations, make the OriGen especially well suited for a desktop computer audio system. Use the OriGen together with headphones and powered speakers to unlock the full sonic potential of your music library. Take Control of Your Music The OriGen lets you quickly and easily configure where your music comes from, and where it goes, at the flip of a switch. Input choices include USB or optical SPIDF, and output can be set to headphones or pre-out to powered speakers/monitors. An optical SPIDF output is also available when using the USB input. Selectable 3.5mm and ¼-inch headphone jacks with dual gain levels let you tailor the headphone amplifier to work with your headphones. You are in control! Digital Finesse The digital circuitry of the OriGen consists of a USB 2.0 High-Speed 480Mbps audio controller and a Cirrus Logic CS4398 MasterHIFI stereo D/A converter. This capable combination provides asynchronous decoding and conversion of PCM audio up to 24-bit/192kHz with exceptionally low noise and distortion. Advanced audio stream interface support includes both ASIO and WASAPI Push/Event output modes. Analog Brawn The analog section of the OriGen provides switchable line-level or headphone output, using JRC NJM4556 op amps with two gain levels of 5.3Vrms and 1.6Vrms. The selectable gain design provides excellent drive capability into any downstream amplifiers with enhanced signal strength, low noise, and low interference. The headphone outputs are similarly powerful, with only 0.5 Ohm output impedance and able to drive 16-600 Ohm headphones. | ![]() B09F32BQPR Price: $219.99 Score: 9.709 Category: Electronics Rating: 4.1 Votes: 6 Find similar productsFX Audio DAC-M1 Bluetooth DAC Amplifier,Audio Converte Video System with ESS9038Q2M XMOS XU208 Chips,BT,Coaxial,Optical Fiber,USB Input. Specification Chipset: ESS9038Q2M +XMOS XU208 +TPA6120A2+ CSR8675 Input options: USBA, OPT, COA, BT Output options: single-ended line, 6.35 headphone output THD+N: 0.00025% Signal to noise ratio: 118dB USB transmission method: asynchronous transmission USB compatibility: Win7, 8, 8.1, 10; Mac OSX 10.6 and above, Linux Sampling rate - USB PCM: 1bit, 16~32Bit/ 44.1~768KHz DSD: 2.8224~22.5792MHz OPT, COA PCM: 1Bit, 16~32Bit/ 44.1~192kHz DSD: DSD64 (DoP) BT PCM: 24Bit/ 44.1~96kHz Headphone output power: 500mW (3292), 340mW (6402), 180mW (1502), 96mW (300Q2) Power consumption: 3.5W Standby power consumption: 0.25W Product size: 13x10x5.5cm Product weight: 300 grams. |
![]() B00Q6VQGS2 Availability: Currently unavailable Score: 9.615 Category: Electronics Rating: 3.9 Votes: 73 Find similar productsMeridian - Explorer2 USB DAC. Get MQA Into Your System for Under $200: Pocket-Sized Meridian Explorer2 USB DAC/Headphone Amp Plays MQA, Offers 24-Bit/192kHz Resolution, Asynchronous USB, Detailed Sound, and Advanced Volume Control True Meridian quality from a pocket DAC and stunning MQA playback ability come in the form of the high-value Explorer2 DAC and headphone amplifier, available for less than $200! Now you can get MQA into your system and enjoy TIDAL Master quality for pennies on the dollar. There's no easier, cheaper way to hear what MQA offers. Explorer2 is your ticket to audio's burgeoning high-res format. An upgraded extended-range 0-100dB volume control that allows for finer adjustments, proprietary technologies taken from the top-of-the-line Reference 800 Series , increased DSP power, and a trademark apodizing filter are among the enhancements on Meridian Explorer2 . A combination USB DAC, preamplifier, and headphone amplifier with exceptional 24-bit/192kHz resolution and in-demand Master Quality Authenticated playback, Explorer2 also offers asynchronous USB, a six-layer circuit board with audiophile-grade components, an auto-sensing headphone input, and 192kHz-derived analog outputs. The extremely powerful built-in headphone amp also makes it a great match for any pair of headphones. Hand-built in the UK, Explorer2 features rugged metal casing with two 3.5mm jacks for headphone listening and dual-sensing outputs. Better yet, improvements over the original critically acclaimed Explorer allow Explorer2 to produce clearer, cleaner, richer sound and removes even more digital artifacts from your music, meaning you'll hear more information and enjoy a much more realistic presentation. Explorer2 is also ready for the future as it has the ability to accept firmware updates to remain compatible with emerging audio technologies. Amazing, and of course, backed. | ![]() B00AHRFBO6 Availability: Currently unavailable Score: 9.174 Category: Electronics Rating: 4 Votes: 6 Find similar productsAune 24bit/192K X1 DAC Headphone Amp & Preamp & USB DAC WM8805 PCM1793 USB Coxia. USB SOUND CARD Project computer receiver from PCM2707 of texas instruments, PCM1793 as sound decoder from i2s output, output from lineout or headphone. DAC project has coaxial digital input, receiving from the WM8805 Chip, which is much better than CS8414. CS8414supports 24bit/192K. Headphone amp project, headphoneamp part refer for the solo line. pre-amp project. This device can be used as a pure pre-amp, the op+buf design. High-grade component adopted,including ALPS audio attenuator, Nichicon capacitors KOA resistor, OMRON Relays. X DAC use a new component ,WM8805 chip , which has the 24BIT/192K DAC Function! The device uses the special audio power amplifier as a single switch to dual IC, the size is as the CD, easy to carry. You can add high capacity batteries for power. Drawing one the forum in the tube USB DAC and HA-2 design experience, using a cariety of advanced headphones actually adjust the sound to further enhance the sound quality. |
![]() B00D4N5UJQ Availability: Currently unavailable Score: 9.009 Category: Electronics Rating: 5 Votes: 2 Find similar productsAlpha Design Labs - ADL X1 - Headphone Amplifier Blue USB DAC Furutech. Headphone listening is an intimate sonic experience and most enthusiasts employ headphone amplifiers and a good pair of 'phones. The headphone amplifier determines the quality of sound in hand with the headphones. The ADL X1 headphone amp from Alpha Design Labs is small but highly specified. It has inputs supporting iOS digital at up to 16/48 via APPLE MFI certified USB Cable for iPod, iPhone, iPad devices. The X1 also runs 24/192 SPDIF with high-resolution files from PC via the PC's USB output. There's also an analog line-level four-pin 3.5mm input and a four-pin 3.5mm output for headphones in the 12~600 ohm range. The four-pin input supports 3.5mm Remote and Mic Earphones. The 3.5mm Toslink optical output delivers USB source signal up to 24/192. There's a convenient GND TRRS switch making it easy to change from one four-pin set of 'phones to another. The X1 gets its great sound from a high-performance 24-bit/192kHz XMOS USB and Sabre ESS-ES9023 DAC chip along with a high quality DD converter for the 3.5mm Toslink optical output. It supports ASIO and asynchronous mode, providing low jitter for realistic sound. The headphone out and line output can connect to your home stereo system. The line input improves the sound of portable analog audio sources. The X1 doesn't draw power from your connected iDevice's battery, because it uses its own internal DC3.7V 2600mAh Li-ion type rechargeable battery or an optional AC adapter. Music playback time is up to 7.5 hours when fully charged. On the desktop, the small size lets it stack easily and fit almost anywhere. With its beautifully-finished aluminum and ABS plastic casing, the X1 looks as elegant as it sounds. It fits in the palm of your hand and lets you enjoy great sounding music anywhere. | ![]() B004M172FY Availability: Currently unavailable Score: 8.850 Category: Electronics Rating: 3.5 Votes: 86 Find similar productsFiiO E9 Desktop Headphone Amplifier and Dock for E7 USB DAC. The FiiO E9 desktop headphone amplifier offers truly stunning audio performance and versatility to headphone and audio enthusiasts. Its sleek and modern form factor, while minimalist in appearance, belies the engineering marvel within. The E9 has exceptionally low noise and distortion, providing enough power to drive the most demanding headphones up to 600 ohm with excellent dynamics and clarity. The E9 also serves as a dock for the E7 USB DAC and portable amp. When combined, the E9 and E7 becomes a seamless high fidelity audio interface for any computer, allowing noisy internal sound cards in computers and laptops to be bypassed. With both a fixed and a volume controlled line level output, the E9 functions well as a pre-amp for driving power amps or active monitors. Features Dock connector for E7 USB DAC, also provides charging power Two gain levels - Low (10dB) and High (18dB) Two line-level outputs - 1/8(3.5mm) volume controlled, and stereo RCA fixed level Internal power converter module with high efficiency, precision, and low noiseSpecifications Output power - 1W (16 ohm); 80mW (600 ohm) Headphone Impedance Range - 16 ohm ~ 600 ohm Frequency Response - 10 Hz - 100 kHz SNR - ~ 100dB (A weight)[LINE IN] Distortion - <0.003% (100mW) [LINE IN] - Line Out - 2V rms Pre Out - 0-2V rms Power - DC15V/ 1.5A Size - 5.9 x 3.8 x 3.8 in. / 149mm 96mm 56mm Weight - 15.6 oz. / 445g. |
![]() B00IWK8FK2 Availability: Currently unavailable Score: 8.547 Category: Electronics Rating: 4 Votes: 9 Find similar productsAune T1 MK2 (Second Generation) 6922 24bit/96kHz Tube Amplifier Mini Hi-fi USB DAC Decoder Black. Specifications:Input Interface: USBMaximum word length:24BitMaximum sampling rate: 192KMaximum DSD rate (DOP) :DSD64Typical line output indicators: RCAOutput voltage level @0dB: 2VrmsFrequency response(from 20Hz to 20kHz) :+-0.5dBTHD+N@1KHz :0.2%NOISE: -105DBHeaphone output power :@300Ω 240mWPackage listings:T1se *1Power adapter *1Manual *1USB cable *16.5mm to 3.5mm stereo F adapter *1. | ![]() B0BM52VPM1 Price: $79 Score: 8.547 Category: Electronics Rating: 4.2 Votes: 94 Find similar productsiFi uno - DAC & Headphone AMP - USB-C Input - Improve Lacklustre Audio - Streaming/Gaming/Music Modes Adjust Sound to Suit You - 32-bit/384kHz/DSD256/MQA - Windows/MAC/Smart Device/Active Speakers. . |
![]() B00C5HZ0ZQ Availability: Currently unavailable Score: 8.403 Category: Electronics Rating: 3.5 Votes: 2 Find similar productsMusical Fidelity - M1SDAC (Black). The M1 SDAC adds a Bluetooth receiver, pre-amplifier and headphone amplifier?to the excellent M1 DAC.?The M1 SDAC can upsample and convert 24bit/192kHz audio and also features an Analogue to Digital Converter, so a digital signal can be passed on from any source. | ![]() B007NXM3K2 Availability: Currently unavailable Score: 8.403 Category: Electronics Rating: 4 Votes: 66 Find similar productsArcam rPAC Personal Audio Converter USB DAC/Headphone Amp. Arcam - rPAC USB / Headphone DAC for PC and MAC. |









