FantasticSearch | E-commerce Search Demo

Scroll to: Top Results

E-commerce Search Demo

AI Assisted Filters

Positive filters:

Negative filters:

Category filter:

Parameters

Query:

Positive filters:

Negative filters:

Category filters: All

AI Assist: ON

Page: 1

Products

Time taken: 4 Max score: 1000.000 Total hits: 600 Full time: 0.0 s
Showing 1-10 of 600 products

B07DZX29ZV Price: $22.95 Score: 1000.000 Category: Tools Rating: 4.5 Votes: 22 Find similar products DEKTITE SQUARE BASE PIPE FLASHING BOOT: #3 (DFE103B) BLACK Square Base EPDM Flexible Pipe Flashing Dektite (for OD pipe sizes 1/4 - 5)~Roof Jack Pipe Boot~pipe flashing. #3 (DF103B) Black Dektite SQUARE Standard Flexible Pipe Flashing Continuous Service Temperature Ranges of -58F to +239F (EPDM)Flashing Base is 8-9/16 X 8-9/16Pipe Boot Fits 1/4 to 5 Outside Pipe DiameterEasily Customized Pipe Boot on the Job SiteEPDM Rubber Boot with Flexible Base (Aluminum Collar)Dektite Base Seals Against Uneven Metal Roofing with EasePipe Flashing Will Not Break or CrackReduced Building MaintenanceFlashing Base Fastener Spacing: 1-1/2Use for Stove Pipes, Chimney, Plumbing, Heating, Air Conditioning, Electrical, Exhaust Vents, etc.20 Year Manufacturer's Warranty Against Manufacturing DefectsOn a roof with a 10/12 to 12/12 pitch Dektite recommends you use a Square base pipe flashing installed with the tip pointed towards roof top. When used with deep ribbed profile panels (1-1/2 deep corrugation or more), consider using the next size up that will accommodate the same diameter pipe. Caution! This product is not rated for temperatures experienced by prolonged contact with a single wall chimney. Failure to follow the products stated directions and specifications for use may result in damage to the Dektite and other items nearby. For single wall chimney applications consider using a high temperature silicone flashing product that is rated for higher temperature applications.	B07ZWHRH2W Price: $97.95 Score: 6.579 Category: Tools Rating: 4.9 Votes: 37 Find similar products Dektite #7 Red Silicone Metal Roof Pipe Flashing, High Temp, Round Base, Pipe OD 6 - 11. #7 (DF207RE) RED Round High Temp Silicone Flexible Pipe Flashing Flashing Base Diameter is 14-3/4 - Fits 6 to 11 Outside Pipe DiameterContinuous Service High Temperature Ranges of -58F to 392F (Silicone)If Trimmed and Installed Correctly, Pipe Flashing Will Not Break or CrackUse for Stove Pipes, Chimneys, Plumbing, Heating, Air Conditioning, Electrical, and Exhaust Vents20 Year Manufacturer's Warranty Against Manufacturing DefectsOn a Roof with a 10/12 to 12/12 Pitch Dektite Recommends You Use a Square Base Pipe Flashing Installed With The Base Tip Pointed Towards Roof Top.When Used With Deep Ribbed Profile Roofing Panels With 1-1/2 Deep Corrugation Or More, Consider Using Next Size Up That Will Accommodate The Same Diameter PipeManufacturers Recommended Temperature Ranges Are Clearly Stated Please Verify This Product Will Meet Specifications Of Your Installation Or Possible Product Damage May Occur.
B01NBLL15G Price: $34.95 Score: 5.882 Category: Tools Rating: 4.6 Votes: 14 Find similar products Dektite #3 EPDM Pipe Flashing 1/4 to 4 by Dektite. Dektite #3 Pipe EPDM Pipe Flashing. Fits pipes 1/4 - 4. 8 inch base diameter. Continuous Service Temperature Ranges of -58F to 239F (EPDM).	B003QSLHW8 Price: $89 Score: 5.236 Category: Tools Rating: 5 Votes: 1 Find similar products Z-Flex 2SVEDWCF04 Z-Vent Drain Pipe Horiz. 4 in. Z-Flex Z-Vent 4 Horizontal Condensation Drain Pipe (2SVEDWCF04). The horizontal condensation drain pipe is used to remove rain water and condensation from the venting system before it can get into the tankless water heater. The horizontal drain pipe is required for all horizontal venting runs that are greater than 5' in length. Z-Flex Z-Vent stainless steel vent pipe is ideal for the Bosch Therm 940ES / Bosch Therm 830ES / Bosch Therm 660EF / Bosch AquaStar 2700ES / Bosch AquaStar 2400ES / Bosch Evolution 500 tankless water heaters as well as the legacy Bosch Pro 715ES / Bosch Pro 635ES / Bosch AquaStar 2400E / Bosch AquaStar 250SX heaters as well as the Bosch AquaStar 240FX, AquaStar 125FX, Takagi TK1, TK2, TKD20, TKJR, TK1S, TM1 tankless water heaters. Z-Flex Z-Vent is rated AL29-4C and is approved for Category I (vertical only), II, III & IV applications and is designed for use with boilers, high efficiency gas and oil heaters and water heaters where cool flue gases are vented under pressure. Z-Vent contains a built-in, fail-safe gasket and locking band connection. No sealant is required.
B002KHZCMC Price: $6.99 Score: 5.051 Category: Tools Rating: 4.5 Votes: 14 Find similar products QC-101 Fernco 1 1/2-in. Flexible Cap. 1-1/2 Fernco Flexible Cap Part No. QC-101 Reusable caps for pipe ends, testing & cleanouts. Qwik Caps offer a quick, easy way to cap pipe ends, cleanouts and open test pipes. Made of flexible PVC, they’re suitable for above- ground or underground use, on cast iron, steel, copper or plastic piping. * Fast, easy installation. * Permanent or temporary cap. * Underground or above-ground. * Low cost and reusable.	B0006OCIQ4 Price: $13.94 Score: 5.025 Category: Tools Rating: 5 Votes: 3 Find similar products Elkhart (06879 Flair-It 3/8 x 3/8 Straight Stop Valve. FLAIR-IT FITTINGS FLARED - CONE & NUT FITTINGS APPLICATIONS FOR HOT & COLD POTABLE WATER FITTINGS - For hot and cold potable water fittings (150 degrees at 100 psi). Squarely cut end of tubing, slide nut over tubing. Firmly press tubing onto the flare of the fitting. Slide the nut to the threads and hand tighten securely onto the fitting. Turn 1/4 more turn with a wrench if necessary. Do not use any 2 inch pipe dopes, sealants, Teflon tape or other chemical on Flair-It connections. However, Teflon tape should be used on male pipe threads when connecting to female threads. When connecting to brass, galvanized steel or CPVC, use a male Flair-It fitting instead of a female fitting. When connecting Flair-It fittings to a water heater in a mobile home, we recommend using a 1/2 inch flex copper connector off of the water heater. From a flex connector to polybutylene, use a Flair-It male adapter. Do not use in a closed loop system. Joints should not be made under concrete. Nuts are included. Flair-It Straight Stop Valve 3/8 inch FL x 3/8 inch FL.
B000DZD2XY Availability: Currently unavailable Score: 5.000 Category: Tools Rating: 5 Votes: 1 Find similar products Oatey 11888 No-Calk Roof Flashing, W X 18 in L, Thermoplastic, 2-Inch. Product Description No-calk roof flashing, 18 in width, 18 in length, thermoplastic, 180 deg F, iapmo listed, used with 2 in pipe diameter. Slides over pipe for pitch to 45 degree. Non-fading and non-cracking, rigid black thermoplastic base. Non-fading, sealing collar. Rated 180 degrees Fahrenheit continuous heat. Not for hot-mopped or built-up roofs. Do not use petroleum-based products on plastic bases or rubber collars. From the Manufacturer Oatey products can be found in residential and commercial applications and have achieved excellent brand name recognition with consumers. All products are backed with the highest quality technical and customer support programs in the industry.	B00M023K8A Availability: Currently unavailable Score: 4.975 Category: Tools Rating: 5 Votes: 1 Find similar products EPDM Black Square Base Pipe Flashing Mini, Pipe Range 1/8 to 3/4 (3.2mm to 19.1mm). Available in 10 various colors of EPDM or orange silicone, all resistant to ultraviolet rays, cracking & weathering.
B000VYJFWE Availability: Currently unavailable Score: 4.878 Category: Tools Rating: 2.9 Votes: 6 Find similar products Sioux Chief 927-7PK2 2-Inch IPS Snap On Floor and Ceiling Plate, Chrome Plated. Product Description Sioux Chief Mfg. Co. Inc. was founded and incorporated in August, 1957 by the late Martin E. Ed Ismert, Jr. in an attempt to smooth the boom-bust housing cycle that his plumbing wholesale supply company experienced. Sioux Chief got its start during the late ‘50s by packaging specialty fasteners and other items geared toward residential plumbing jobs. In the early ‘60s, Ed borrowed the idea of spinning copper tube closed for simple air chambers and adapted it for stub outs which could be used by plumbers. This performed copper tube saved plumbers from sweat soldering tube caps onto their copper tube for water shock and test-off purposes. By 1975 a heavy emphasis on sales and new product development began when Eds two eldest sons purchased the corporation and took over operations. Since then Sioux Chief has introduced a wide range of innovative products. From the Manufacturer Sioux Chief Mfg. Co. Inc. was founded and incorporated in August, 1957 by the late Martin E. “Ed” Ismert, Jr. in an attempt to smooth the boom-bust housing cycle that his plumbing wholesale supply company experienced. Sioux Chief got its start during the late ‘50s by packaging specialty fasteners and other items geared toward residential plumbing jobs. In the early ‘60s, Ed borrowed the idea of spinning copper tube closed for simple air chambers and adapted it for stub outs which could be used by plumbers. This performed copper tube saved plumbers from sweat soldering tube caps onto their copper tube for water shock and test-off purposes. By 1975 a heavy emphasis on sales and new product development began when Ed’s two eldest sons purchased the corporation and took over operations. Since then Sioux Chief has introduced a wide range of innovative products.	B0071C0E6A Price: $128.95 Score: 4.878 Category: Tools Rating: 4.5 Votes: 128 Find similar products Dektite #8 Red Silicone Metal Roof Pipe Flashing, Round Base, Pipe OD 7 - 13. 1391980.