FantasticSearch | E-commerce Search Demo

Scroll to: Top Results

E-commerce Search Demo

AI Assisted Filters

Positive filters:

Negative filters:

Category filter:

Parameters

Query:

Positive filters:

Negative filters:

Category filters: All

AI Assist: ON

Page: 1

Products

Time taken: 3 Max score: 1000.000 Total hits: 100 Full time: 0.0 s
Showing 1-10 of 100 products

B07S21VBSZ Availability: Currently unavailable Score: 1000.000 Category: Electronics Rating: 4.3 Votes: 6 Find similar products Maxmoral 10PCS AMS1117-3.3 DC-DC Voltage Regulator Power Supply Step Down Module 3 Pins 3.3V DC Buck Converter. Dimensions: 8.6mm x 12.33mm Output voltage: 3.3V Output current: 800 mAh (load current may not exceed 800 mAh) Operating temperature range: -40 to 125 centigrade Storage temperature: - 65~150 centigrade Application: Arduino UNO MEGA2560; MSP430 Development Board; 3.3V Low power consumption MCU; FPGA/CPLD PLD Programmable Logic Systems; ARM7 ARM9 ARM11 STM32.	B088FWTGKH Availability: Currently unavailable Score: 11.905 Category: Electronics Rating: 3.5 Votes: 16 Find similar products Teyleten Robot 10pcs 3 Pins AMS1117-3.3 DC 4.75V - 12V to 3.3V Step Down Power Supply Buck Voltage Regulator 800mA Module. .
B0B63C1458 Price: $22.99 Score: 9.259 Category: Electronics Rating: 4.5 Votes: 31 Find similar products BULVACK 20-Pack LM2596 DC to DC High Efficiency Voltage Regulator 3.0-40V to 1.5-35V Buck Converter DIY Power Supply Step-Down Module. Electrical Parameters: Input Voltage: DC 3 -40 V Output Voltage: DC 1.5 - 35 V Output Current: 3A(MAX) It is recommended to use under 2A (NOTE: When using high power, add a heat sink to the power supply chip) Load adjust ratio: +/-0.5% Voltage adjust ratio: +/-2.5% Transferring efficiency: 92% Max(the higher output voltage, the higher efficiency) ON/OFF frequency: 150KHz Output ripple: 200mV Module feature: buck and non-isolated Rectification method: non-synchronous rectification Function: 1.Built in over-temperature protection function 2.Built in current limit function 3.Built in output short-circuit protection function How to use： 1.Access the power supply ( 3 -40 V), the power indicator light, the module is working properly. 2.Adjust the blue potentiometer knob (usually clockwise rotation boost, counterclockwise rotation Step-down) and monitor the output voltage with a multimeter to reach the required voltage. 3.A customer reflects the module output voltage can not be adjusted, always equal to the input voltage. When you encounter this problem, please first counterclockwise rotation potentiometer 10 laps above, and then use the module can be normal adjustment of the voltage. Package includes: 20 X LM2596 board Note: This is a buck module. The input voltage must be higher than the output voltage. The input and output interface can not be reversed. It is recommended to use the current within 2.5A when working for a long time. If it exceeds 2A, you need to add a heat sink (output above 10W).	B092479721 Price: $18.99 Score: 9.091 Category: Electronics Rating: 4.1 Votes: 226 Find similar products ACEIRMC XL6019 5A High Power Current DC to DC Step-up 5V 6V 12V 24V 3-35V to 5-40V XL6019 Converter Adjustable Voltage Regulator Power Modules Boost Module Booster (10pcs). Description： MS + -> Positive; IN ---> Negative; OUT + -> Positive; OUT ---> Negative Input Voltage: DC 3-35 V(40V MAX) Output Voltage: DC 5-40V ( 45V MAX Adjustable) Input Current: 5A (MAX) Conversion efficiency: 94% (MAX) Output ripple: 100mv (MAX) Switching Frequency: 220 kHZ Working Temperature: Industrial (-40 ° C to + 85 ° C) Voltage regulation: ± 0.5% Load regulation: ± 0.5% Size: Approx 50 * 28 * 13mm (L * W * H) Instructions: Input and Output must be connected correctly Conventional Constant Voltage Output BOOST Fully Integrated Solutions, Integrated MOSFET, Fewer External Components, Smaller Cos System Built-in over temperature protection, full set overcurrent protection circuit reliability, high reliability TO263-5L standard package, suitable for 30W boost inside applications. Power (3-35 V), power indicator light, module is working properly. Adjust the blue knob of the potentiometer (counterclockwise general impulse, buck clockwise rotation) and with a multimeter to monitor the output voltage reaches the required voltage NOTE: Long hours working current is recommended for use at less than 2.5 M, while adding heatsink mass (10 W output above); Because it is boosting the module, in order to ensure stable output, please keep the minimum differential 1.5 V. Package： 3 * XL6019 5A Current DC to DC Adjustable Boost Power Supply Board Module.
B008BHBEE0 Price: $14.95 Score: 8.850 Category: Electronics Rating: 4.1 Votes: 52 Find similar products 10 pcs LM2596 DC-DC Buck Converter Step Down Module Power Supply Output 1.23V-30V. Input: DC 3V to 40V (input voltage must be higher than the output voltage to 1.5v above can not boost) Output: DC 1.5V to 35V voltage continuously adjustable, high-efficiency maximum output current of 3A. Features: All SANYO solid capacitors, the 36u thickening circuit boards, high-Q inductance with output value of high-power LED indicator Dimensions: 45 (L) * 20 (W) * 14 (H) mm (with potentiometer).	B08GHT4VK9 Price: $19.59 Score: 8.850 Category: Electronics Rating: 3.4 Votes: 2 Find similar products AITRIP 6PCS MCP2515 CAN Bus Module TJA1050 Receiver SPI Module Compatible with Arduino AVR 51 MCU ARM Controller Development Board TE534. Specifications: Working voltage: DC 5V Working current: 5mA (1 microamp standby current. Except the power indicator) Dimension: 4.4cm x 2.8cm/ 1.73x 1.10inch Screw hole center spacing: 23mm x 38mm Features: 120 ohm termination resistors. With impedance matching, ensures the drive capacity, long-distance data transmission against signal radiation. 5V DC power supply module, SPI interface protocol control. Supports CAN V2.0B specification, the communication speed 1Mb/s. 0 to 8-byte data field. Standard frame and expand the frame and remote frame Working temperature: Industrial grade to 85 ℃ -40 ℃ Package Includes: 6 Pieces MCP2515 CAN Bus Modules.
B08214MRSW Price: $7.39 Score: 8.772 Category: Electronics Rating: 4.3 Votes: 18 Find similar products DAOKI 10Pcs 5V to 3.3V Step-Down Power Supply Buck Module DC 4.75V-12V to 3.3V Voltage Regulator AMS1117-3.3 LDO 800MA Buck Module Soldering Kit. .	B008BHQFFI Price: $20.95 Score: 8.403 Category: Electronics Rating: 4 Votes: 19 Find similar products 20 pcs LM2596 DC-DC Buck Converter Step Down Module Power Supply Output 1.23V-30V. Input: DC 3V to 40V (input voltage must be higher than the output voltage to 1.5v above can not boost) Output: DC 1.5V to 35V voltage continuously adjustable, high-efficiency maximum output current of 3A. Features: All SANYO solid capacitors, the 36u thickening circuit boards, high-Q inductance with output value of high-power LED indicator Dimensions: 45 (L) * 20 (W) * 14 (H) mm (with potentiometer).
B09LLZMM1C Price: $20.59 Score: 8.264 Category: Electronics Rating: 4.4 Votes: 18 Find similar products AITRIP 10PCS 4PCS AC/DC to DC Step Down Buck Converter AC 5-30V DC 5-48V 24V 36V 48V to DC 2.5-35V 12V Voltage Regulator Board 2A Adjustable Volt Power Supply Module. Features 1: A: The power module adopts the plug-in LM2596HV, the high voltage version of the LM2596. The maximum input voltage is 50V (limited by the filter capacitor withstand voltage). The external heat sink can withstand high current operation. The input terminal uses a 4A rectifier bridge stack to input AC power, and has a dedicated DC input port, which is commonly used for AC and DC input. The output voltage can be adjusted from 3.3V to 33V, and the output voltage will vary with different input voltage ranges. B： Input AC voltage AC5V-AC30V or DC5V-50V, due to the large fluctuation of AC voltage, the recommended AC voltage range has reserved margin. The power module has a maximum input voltage of 50V (limited by the filter capacitor withstand voltage) and a heat sink. The output current can work stably at 2.2A output current for a long time, and can work at 3A output current for a short time. The front of the PCB has the name of the silk screen terminal, and the back side also has the name of the silk screen terminal. When soldering the lead, please recognize it and solder it to prevent damage. Futures 2: Input voltage range: AC 5V-30V, DC 5V-50V Output output range: DC 3.3V-33V Output current range: up to 2.2A (the regulator chip can withstand a maximum current of 3A, can work at 3A output current for a short time Module size: 51mm*26mm Package： 10pcs LM2596HV AC/DC to DC Buck Converter Module 3v 3.3V 5V 6V 9V 12V 15V 24V DC 5V-50V Adjustable Step-Down 3A LM2596 Power Supply.	B018U19MN6 Price: $9.29 Score: 8.197 Category: Electronics Rating: 3.4 Votes: 24 Find similar products 5pcs LM317 DC-DC Converter Buck Circuit Board Adjustable Linear Regulator. Description: Output Current: 1.5A (min), 2.2A (type) Input-output voltage differential (VI-VO): 40Vdc (max) Adjustable output voltage range: 1.2 ~ 37V Operating temperature: -55? to +150? Current output: 1.5A Voltage Input: 4.2 ~ 40 V Characteristic frequency: 100 (MHz) Module size: 35.6 (mm) x16.8 (mm) Package included: 5 pcs LM317 DC-DC Converter Buck Circuit Board Adjustable Linear Regulator.