FantasticSearch | E-commerce Search Demo

Scroll to: Top Results

E-commerce Search Demo

AI Assisted Filters

Positive filters:

Negative filters:

Category filter:

Parameters

Query:

Positive filters:

Negative filters:

Category filters: All

AI Assist: ON

Page: 1

Products

Time taken: 4 Max score: 1000.000 Total hits: 100 Full time: 0.0 s
Showing 1-10 of 100 products

B08978VFS8 Availability: Currently unavailable Score: 1000.000 Category: Electronics Rating: 4 Votes: 10 Find similar products DAOKI 2Pack DC-DC Boost Converter Module 10-40V to 10-50V 10A 250W Adjustable Step Up Voltage Regulator CC CV Power Supply Module with 24AWG Cable. Description: Module properties: non-isolated step-up module (BOOST) Input voltage: DC10V-40V Input current: 6A (MAX) exceeds4A please enhance heat dissipation Quiescent current: 10mA (12V liter 20V, the output voltage, the higher the current will increase too quiet) Output voltage: 10-50V continuously adjustable Constant] range: 0.2-6A Temperature: -40 to + 85 degrees (ambient temperature is too high, please enhance heat dissipation) Operating frequency: 150KHz Conversion efficiency: up to 96% Overcurrent protection: There Input reverse polarity protection: Yes Applications: 1. DIY a power supply, 12V can input and output can 12-50V adjustable. 2. the power supply for your electronic device, according to your system can set the output voltage value. 3. as the car power supply for your laptop, PDA or a variety of digital products supply. 4. DIY a mobile notebook power supply: 12V coupled with high-capacity lithium battery pack, so you can go where light where books. 5. solar panel regulator. 6. to the battery, rechargeable lithium batteries. 7. driving high-power LED lights. Package Included: 2 x DC-DC Boost Converter Module 250W 1 x 19.6 24AWG Wire.	B07F266X24 Availability: Currently unavailable Score: 11.236 Category: Electronics Rating: 4.6 Votes: 8 Find similar products Power Supply Module 5V, DROK 2pcs Mini USB Boost Converter DC-DC Step Up Voltage Regulator Transformer 3V to 5V 2A Volt Step-up Circuit Board. Feature: Module properties: non-isolated step-up module (BOOST) Input voltage: 2.6-5.5V Input Current: 0-3A Output voltage: 5V Output current: 0-2A Operating temperature: -40°c to +85°c Working frequency: 1.2MHz Conversion efficiency: up to 93% Short circuit protection: Yes Over-temperature protection: Yes (Over-temperature automatic shutdown output) Input reverse polarity protection: No (please install diode at input port) Power indicator: 3.6V Red LED Light Installation: two 3mm screws Connection: V-IN input, USB output Dimensions: 20x20x6.8mm Package Include: 1x Mobile Power Supply Module.
B076TTBKFG Availability: Currently unavailable Score: 10.101 Category: Electronics Rating: 4 Votes: 77 Find similar products Boost Voltage Converter, DROK 1500W Voltage Regulator DC 10-60V Step Up to 12-90V 20A Input Power Supply Module Volt Transformer Circuit Board. DROK 1500W Boost Voltage Converter Parameters: Module type: non-isolated step-up module (BOOST) Input voltage range: DC 10V~60V Input current: 10~30V input voltage, maximum current 30A; 31~60V input voltage, maximum current 25A Static operating current: 15 mA (when 12V step up to 20V, the higher the output voltage, the current will increase) Output voltage: 12~90V continuously adjustable (default 19V) Output current: 20A MAX, more than 15A please enhance heat dissipation Constant current range: 0.8~20A (±0.3A) Temperature: -40~ + 85℃(if the ambient temperature is too high, please enhance heat dissipation) Operating frequency: 150 KHz Conversion efficiency: 92% ~ 97% Protection: input over-current protection, battery low voltage protection, input reverse polarity protection, input short circuit protection Installation: 4 x 3 mm screw holes Module size(LWH): 130 x 52 x 85 mm Applications: 1. DIY a power supply, input 12V and output can be 12-90V adjustable. 2. Charge for your electromobile. 3. As the car power supply, charge for your laptop, PDA or a variety of digital products. 4. DIY a notebook mobile power supply: with 12V big-capacity lithium battery pack, get your notebook on anywhere. 5. Solar panel regulator. Note: This item is not designed with display. If need to check output current various, please use a multimeter. Package Including: 1 x Power Converter Module.	B0B63C1458 Price: $22.99 Score: 9.901 Category: Electronics Rating: 4.5 Votes: 31 Find similar products BULVACK 20-Pack LM2596 DC to DC High Efficiency Voltage Regulator 3.0-40V to 1.5-35V Buck Converter DIY Power Supply Step-Down Module. Electrical Parameters: Input Voltage: DC 3 -40 V Output Voltage: DC 1.5 - 35 V Output Current: 3A(MAX) It is recommended to use under 2A (NOTE: When using high power, add a heat sink to the power supply chip) Load adjust ratio: +/-0.5% Voltage adjust ratio: +/-2.5% Transferring efficiency: 92% Max(the higher output voltage, the higher efficiency) ON/OFF frequency: 150KHz Output ripple: 200mV Module feature: buck and non-isolated Rectification method: non-synchronous rectification Function: 1.Built in over-temperature protection function 2.Built in current limit function 3.Built in output short-circuit protection function How to use： 1.Access the power supply ( 3 -40 V), the power indicator light, the module is working properly. 2.Adjust the blue potentiometer knob (usually clockwise rotation boost, counterclockwise rotation Step-down) and monitor the output voltage with a multimeter to reach the required voltage. 3.A customer reflects the module output voltage can not be adjusted, always equal to the input voltage. When you encounter this problem, please first counterclockwise rotation potentiometer 10 laps above, and then use the module can be normal adjustment of the voltage. Package includes: 20 X LM2596 board Note: This is a buck module. The input voltage must be higher than the output voltage. The input and output interface can not be reversed. It is recommended to use the current within 2.5A when working for a long time. If it exceeds 2A, you need to add a heat sink (output above 10W).
B092479721 Price: $18.99 Score: 9.901 Category: Electronics Rating: 4.1 Votes: 226 Find similar products ACEIRMC XL6019 5A High Power Current DC to DC Step-up 5V 6V 12V 24V 3-35V to 5-40V XL6019 Converter Adjustable Voltage Regulator Power Modules Boost Module Booster (10pcs). Description： MS + -> Positive; IN ---> Negative; OUT + -> Positive; OUT ---> Negative Input Voltage: DC 3-35 V(40V MAX) Output Voltage: DC 5-40V ( 45V MAX Adjustable) Input Current: 5A (MAX) Conversion efficiency: 94% (MAX) Output ripple: 100mv (MAX) Switching Frequency: 220 kHZ Working Temperature: Industrial (-40 ° C to + 85 ° C) Voltage regulation: ± 0.5% Load regulation: ± 0.5% Size: Approx 50 * 28 * 13mm (L * W * H) Instructions: Input and Output must be connected correctly Conventional Constant Voltage Output BOOST Fully Integrated Solutions, Integrated MOSFET, Fewer External Components, Smaller Cos System Built-in over temperature protection, full set overcurrent protection circuit reliability, high reliability TO263-5L standard package, suitable for 30W boost inside applications. Power (3-35 V), power indicator light, module is working properly. Adjust the blue knob of the potentiometer (counterclockwise general impulse, buck clockwise rotation) and with a multimeter to monitor the output voltage reaches the required voltage NOTE: Long hours working current is recommended for use at less than 2.5 M, while adding heatsink mass (10 W output above); Because it is boosting the module, in order to ensure stable output, please keep the minimum differential 1.5 V. Package： 3 * XL6019 5A Current DC to DC Adjustable Boost Power Supply Board Module.	B097DM5733 Price: $23.99 Score: 9.804 Category: Electronics Rating: 4.4 Votes: 8 Find similar products XWST DC DC Stabilizer 9V-36V to 13.8V Boost Buck Converter 5A 69W Waterproof Automatic Voltage Regulator Auto Step Up Down 13.8V Volt Transformer Module. XWST DCDC Power Supply Stabilizer Module Technical Specification: Input Voltage: DC 9V~36V (12V 24V) Output Voltage: DC 13.8V Output Current: 5A Output Power: 69W Conversion Efficiency: >93% No Load Voltage Range: Set voltage ±3% Load Regulation: ±3% Quiescent Power Dissipation: <10mA Operating Temperature: -25~65℃ Storage Temprature: -40~80℃ Operating Humidity: 10%~90% Waterproofing Grade: IP67 Over-current Protection: Yes Over-temperature Protection: Yes Short-circuit Protection: No Size: 74mm x74mm x 32mm Net Weight: 260g Material:aluminium shell Note: 1. Connect the wiring in strict according with the wiring instruction. 2. Use short and thick input & output wire to ensure output enough voltage and power. 3. If there are multiple output wire, do not combine the load. 4. Leave a margin for the power supply to ensure it can long-term stably working. Package Included: 1x DC-DC Stabilizer.
B06XZ49ZS9 Price: $7.99 Score: 9.709 Category: Electronics Rating: 5 Votes: 2 Find similar products 5 PCS Buck Converter, Icstation LM2596S DC-DC Voltage Regulator Step Down Converter Module Power Supply 4-35V to 1.25-35V 3A. .	B071CWMRYD Price: $10.58 Score: 9.709 Category: Electronics Rating: 4.3 Votes: 113 Find similar products DZS Elec 12A DC-DC Step Down Buck Converter Low Ripple with Heat Sink 4.5V-30V to 0.8V-30V Vehicular Voltage Regulator. Feature: Module Name: 12A DC Step Down Buck Converter Module Type: Non-isolated step-down module Module Size: 605122mm Input Voltage: 4.5V-30V Output Voltage: 0.8V-30V ( continuously adjustable ) Output Current: 0A-12A 100W ( Can be up to 200W if enhance heat dissipation ) Work Temperature: -40 degree to + 80 degree Switching Frequency: 300KHz Transfer Efficiency: 95% (MAX) Short-circuit Protection: Yes (Limited current 14A) Over-temperature Protection: Yes (Automatically shut off the output once over temperature) Reverse Voltage Protection: NO ( If need, please add large current tube.) Connection Mode: Terminals or solder terminals. V-IN for input, V-OUT for output The module has enhanced aluminum radiator and TVS tube, which make sure the work temperature be lower and safer. 50V/MLCC chip capacitor, combined with high frequency low resistance electrolytic condenser, make the output ripple lower. Suitable for DIY of storage battery, power transformers, adjustable voltage regulator, 24V power supply, LED lights power supplies, industrial equipment step-down etc. and other work requirements. 12V to 3.3V, 12V to 5V, 24V to 5V, 24V to 12V and so on. Transfer Efficiency test data: Input 12V, Output 5V/10A, Efficiency 81% Input 12V, Output 5V/6A, Efficiency 86% Input 24V, Output 12V/8A, Efficiency 91% Input 24V, Output 19V/6A, Efficiency 94% Package Include: 1pcs 12A DC Step Down Buck Converter.
B07X7DZNRG Price: $7.79 Score: 9.524 Category: Electronics Rating: 3.2 Votes: 6 Find similar products HiLetgo 2pcs LM317 DC Linear Voltage Converter Module Voltage Regulator Board Speed Control Module DC 3.25-15V. Input voltage: DC 3.25-15V Output voltage: DC1.25V-13V Output current: 5-1500MA Size: 33.5 * 30.5 * 24mm (excluding protruding knob) Install Aperture: M3 * 4 Input terminal: XH-2.54-2P Output terminal: XH-2.54-2P KF2510-3P Chip: overheating, over-current, short circuit protection Ambient temperature: -10 ~ 85 °C Storage temperature: -65 ~ 150 °C Package Included: 2* LM317 DC Linear Voltage Regulator Converter Module.	B07JYX4J4N Availability: Currently unavailable Score: 9.524 Category: Electronics Rating: 3.5 Votes: 20 Find similar products ZYAMY LM2596S Buck Converter DC-DC Adjustable 3A Step Down Power Supply Module Voltage Regulator. Parameter: Name: LM2596S Step Down Buck Converter Size: 43x21x14mm (LxWxH) Quantity: 1pc 1. Input Voltage: 3.2-35V Adjustment: First connect the input power supply correctly (between 3.2V-35V), then use a multimeter to monitor the output voltage and adjust the potentiometer (generally turn clockwise to boost voltage, turn counterclockwise to reduce voltage). 2. Output Voltage: 1.25-30V continuously adjustable (No-load debugging is recommended) 3. Output Current: Rated current 1A, MAX 2A (Need heat sink), if output power is more than 15W, please add heat sink. 4. Transfer Efficiency: 92% max, (Higher output voltage, higher efficiency.) 5. Static Power Consumption: Approx. 3mA 6. Please keep 1.5V minimum voltage difference to ensure stable output. Note: When adjusting voltage, the load should be connected first and the power should be off. Counterclockwise is buck, clockwise is boost.